Keep your welder ready to fire up in any weather with our complete 120V Engine Block Heater Kit for F162/F163 motors on SA-200/SA-250(GAS) welders. This complete kit is a must-have for anyone looking to avoid the slow starts and wear on engines during cold snaps. With a direct coolant connection from the water pump to the block heater, then to the engine block, your welder heats up efficiently, ensuring it's ready to go when you are. The kit packs everything you need for a hassle-free installation including the heater unit, three precise fittings, durable hoses, mounting hardware, and step-by-step installation instructions. Don’t let the cold slow you down—get your welder winter-ready today!

NOTE: If your water pump is not pre-drilled, tapped, and plugged then the installer must drill and tap to insert the fitting's 3/8" end into the water pump. See the 2nd picture.

Use an extension cord to run it to a 120V receptacle. Get a 14/3 100-ft or 50-ft extension cable here.

Call us with any questions 602-850-7399.