Lincoln SA-200 SA-250 5-Gauge Kit for Electronic Ignition System

This is a 5-Gauge Kit of Fuel Level, Ammeter, Temperature (mechanical), Hour Meter, & Oil Pressure Gauges, fittings, connectors, and relay for an SA-200 or SA-250 (with mechanical Temperature) Lincoln Pipeliner welder.
Use 12-gauge automotive wire to/from the Ammeter and 14-gauge automotive wire on everything else. 
THIS GAUGE SETUP IS DESIGNED TO SHUT-OFF YOUR WELDER IN CASE OF LOW OIL PRESSURE OR A HIGH COOLANT TEMPERATURE SITUATION AND THE RED LIGHT (OPTIONAL) WILL ILLUMINATE.
***** VERY IMPORTANT *****
Follow the directions included with the gauges to set the oil pressure trip to just under 15 psi and coolant temperature trip to 235 deg F to shut-off your welder!!
**********
The Kit contains:

2 – Blue Male Terminal  BW1876
2 – Blue Female Terminal  BW1875
1 – Yellow Male Terminal  BW1877
1 – Yellow Female Terminal  BW1874
1 – Fuel Level Gauge  BW1147
1 – Fuel Level Gauge Sending Unit  BW1148
1 – 5-pin Relay Connector Plug  BW1860
1 – Murphy Ammeter +/-60Amp Gauge  BW296
1 – Murphy Temperature Gauge (different for the two machines)
      BW1890-K is for SA-200:  BW165
      BW2013-K is for SA-250:  BW351
1 – Hour Meter 10-80 Volts  BW317
1 – 56-inch Braided Brass Hose Assembly  BW56
1 – 5-pin Relay  BW1117
1 – Run Tee, 1/8 Brass Fitting  BW207
1 – Brass Elbow Pipe Fitting  BW525
1 – Murphy Oil Pressure Gauge (0-75 psi)  BW228

Optional:
1 – Red Indicator Light
       BW1890-K-L is BW1890-K above with indicator light  BW1900
       BW2013-K-L is BW2013-K above with indicator light  BW1900

The optional indicator light, when illuminated, indicates there is a temperature or oil pressure issue that has shut down your engine.

Call us with any questions 602-850-7399.